VOOPOO Drag Review – Features and Functions
If you are familiar with VOIP (Voice Over Internet Protocol) phones, then you have surely heard of the Voopoo Drag. This is a new phone manufactured by VOIP provider, Softoon. It is not a true telephone in the usual sense. Rather, it is a phone that has an analog output port (the microphone on the other end) and a digital input port (the keyboard on the other end). In fact, it is so far removed from the conventional telephone that some people might mistake it for a portable computer. But its true function is to make telephone calls with the comfort and convenience of a home phone while adding a number of extra features that would truly be enjoyed by a typical user.
The exterior design of the voodoo drag is based on ergonomics. In particular, it is a phone that has a full QWERTY keyboard and a touch-sensitive screen. Although you can press and hold the power key during normal operation, you cannot do that when you are in the midst of calling. So, the screen was designed to make it easier to operate. In addition, a recessed keypad on the side of the phone allows for convenient access to important functions.
On the other hand, the body of the VOOPOO drag is designed primarily for convenience. It is smaller than your average modern cell phone and it has a durable, shockproof construction. Also, you will find a built-in rechargeable battery inside the unit, which provides up to two hours of operating time on a single charge. That means that you can enjoy a vaper smoking experience while keeping your hands to yourself.
The VOOPOO drag comes with two styles of rechargeable batteries. One style is a standard lipo style battery, while the other one is called the extended lipo style. Both styles are high capacity and have lipless ceramic cartridges. The Lipless style is designed especially to be used with vaporizers and is capable of producing ten times more vapors than its standard counterpart. So, it makes sense that the VOOPOO drag has lipless batteries.
The body of the VOOPOO drag also includes a pod tank that houses two dual 18650 batteries, one for each of the front and rear sets of the trigger. This allows you to enjoy a continuous draw until your desired temperature has been reached. The pod tank has a silicone ring to help keep it closed. However, this ring may become loose over time and can damage the battery, so it is important to keep the pod tank tightly sealed. The two sets of batteries are securely held in place by two silicone “buttons” that match the colors of the buttons on your RHA.
The VOOPOO drag 2177w features a novel micro circuitry that is capable of increasing the power output of the unit through the microprocessor. This increases the overall power for your drag device. Many users have reported increased power output while only using the microprocessor. It is not recommended that you use your drag power output sub-ohm tank without the pod tank because the pod tank is what controls the power of the device. The microprocessor will automatically switch the power output depending on the temperature of the room, which means that you do not have to manually switch the power on and off when changing airflow levels.
The VOOPOO drag has a highly advanced 32-bit gene chip that is powered through a rechargeable li-polymer battery. When the gene chip is powered on, it starts at the zero resistance setting and continually progresses until the pressure is exceeded. At the end of the charge cycle, the chip determines the resistance level and adjusts the airflow for perfect airflow. This is a very accurate method of determining the resistance level and can be programmed for any desired resistance based on the oled display settings. The highly advanced 32-bit gene chip gives the user the ability to adjust the resistance based upon peak and average power, performance, or the time it has been run.
One of the unique features of the VOOPOO drag is the ability to program an infinite airflow system. The unique system works by having two adjustable air ports, one in the top port and one in the bottom port of the unit. The pod is used to hold the old screen and when the screen is touched the pod releases the old display. The unit has an intuitive user interface that allows users to easily change settings without having to understand any complex documentation. This also allows the user to program a desired temperature for their VOOPOO drag.